Dragonfly Hurricane 2207 KV2500 Brushless Motor for FPV Racer

• Specially deisigned for FPV racing with extreme performance
• Fast response and ultimate efficiency
• New technology to ensure smooth running
• Precise balanced and fully tested

Powerful, reliable, and quick. This is the latest Dragonfly Hurricane 2207 2500KV brushless motor that specially designed for FPV racing and extreme performance. These Dragonfly Hurricane 2207 2500kv motors feature an open air base to allow for more efficient cooling of the motors. Weighing in at just 30.5 grams helps eliminate some weight compared to other motors and fits with most racers desire to shave precious grams off builds wherever they can.

Product Link: https://www.fpvmodel.com/dragonfly-hurricane-2207-kv2500-brushless-motor-for-fpv-racer_g1385.html

Features:

• Featuring 20awg silicone wire, N52SH magnets and Japanese NSK bearings these motors are sure to fit the needs of most FPV racers.
• We use high quality aluminum and rare-earth magnetic materials, and redesigned the magnetic circuit of Dragonfly Hurricane to make sure the motors come with a better loading capacity.
• We have greatly improved their thrust and efficiency comparing to other motors on the market. At the same time, we have enhanced the response speed to guarantee the smooth flying of your racing quad
• The use of special aluminum material for body structure, not only comes with a greater strength than those motors made of the 6 series aluminum that most other motors use, but also greatly reduce the weight. 
• The motor shaft has abandoned the traditional way of installation, the spindle completely goes through the threaded shaft to improve the friction between steel shaft and threaded sleeve of head cover. It also improves the concentricity of motor rotor and effectively increases the strength of propeller shaft, so that to make sure the motor can survive from the hard crashes.
• The Draongfly Hurricane has added an insulation film between bottom cover and spindle to isolate the connection between screws and copper wires. In this way, the motor is able to prevent from short circuit and leakage that caused by misoperation.

Specifications:

KV: 2500KV
No.of Cells(Lipo): 3-5S
Configuration: 12N14P
Stator Diameter: 22mm
Stator Length: 7mm
Shaft Diameter: 5mm
Motor Dimension (Dia.*Len): Φ27.9×32.7mm
Weight(g): 30.3g(Excluding Cable）
Recommend Propeller: 5″
Recommend ESC: 30-50A
Wire AWG: 20AWG|
Magnet: N52SH
Stator: Japan KAWASAKI
Bearings: Japanese NSK, 693zz, 3x8x4

These Dragonfly Hurricane 2207 2500kv motors feature an open air base to allow for more efficient cooling of the motors. Weighing in at just 30.5 grams helps eliminate some weight compared to other motors and fits with most racers desire to shave precious grams off builds wherever they can.

We use high quality aluminum and rare-earth magnetic materials, and redesigned the magnetic circuit of Dragonfly Hurricane to make sure the motors come with a better loading capacity.

Featuring 20awg silicone wire, N52SH magnets and Japanese NSK bearings these motors are sure to fit the needs of most FPV racers.

The Draongfly Hurricane has added an insulation film between bottom cover and spindle to isolate the connection between screws and copper wires. In this way, the motor is able to prevent from short circuit and leakage that caused by misoperation.

BetaflightF7 RV1 Flight Controller

Betaflight F7 is here and it features a completely new layout. Top mounted solder pads ensure ease of access for the even the trickiest of builds. The Betaflight F7 features dual gyros so the user can have their choice of which one to use, either the tried and true MPU6000, or the ICM20608. 

Product link: https://www.fpvmodel.com/betaflightf7-rv1-flight-controller_g1393.html

You’ll find the specs listed below:

Specifications:

• 3-6s 
• Simplistic Layout
• Two Gyro options
• Betaflight OSD
• Filtered output for FPV systems
• Smart Audio/Tramp Telemetry compatibily
• 4 uarts (can read inverted and univerted signals)
• Camera Control 
• Buzzer
• Blackbox via flash memory 
• 30.5x30.5 FC mounting

BetaflightF7 Setup Guide:

 

Features: 

Programmable LEDs, Flash Memory, individual pad for camera control, labeled Smart Audio/Tramp TX1 next to VTx soldering pads. Labeled Smart Port TX2 pad next to Sbus/Ibus/DSM2 UART6 Tx, 5v and 3.3v pads (user selection based on type of receiver used), four pads for ESC telemetry connected to RX1.(Each pad placed near corners of the board) 

By Philipp Seidel, Click to Enlarge

• betaflight_3.3.0_BETAFLIGHTF7.zip
• Betaflight F7 Quick Setup Guide.pdf

Skywalker SMART 996mm Wingspan EPO FPV Racing Wing RC Airplane Kit

Skywalker Smart: https://www.fpvmodel.com/skywalker-smart-996mm-wingspan-epo-fpv-racing-wing-rc-airplane-kit_g1362.html

FPV wing racing is a growing quickly and has the peotential of being bigger than mini quad racing due to the facts that wings are faster than miniquads and easier to see in a race. Being easier to see in a race allows spectators to feel more involved while watching an event. 

This potential has been noticed by Skywaker and now Skywalker is throwing in their own design ideas with Skywalker Smart. Skywalker Smart is a dual motor design that is focused on serious power, allowing the user to climb to speed over 140kph. Featuring a 996mm wingspan, Skywalker Smart is large enough to get all your gear in the air but small enough to ensure lightning fast speeds with quick and agile air manuevers. Skywalker Smart can have several different methods of take off with two most common methods of take off being hand tossed or vertical launch. Skywalker Smart FPV Racing Wing doesn’t stray to far away from the mini quad racing scene and if your familiar with mini quads you’ll feel right at home with this built. 

The motors, escs, fpv gear ,and flight contollers are all the same specs that you find in your typical mini quad build. Recommended motors are 2206 2300kv with 35a ESC combinations. For awesome flight controller preformace with the much need PWM out puts servo and motor connection we recommend X-Racer F4 flight controller. You can find a review and detailed description by Oscar Liang here.

Specification: 

• Wing span: 996mm
• Fuselage length: 430mm
• Wing area: 25.9m2
• C.G.: From head to back 240-250mm
• Flying weight: 750g-1000g
• Takeoff：Hand cast
• Landing: Belly Landing
• Air speed: 60km/h
• Maximum of flying time: 30min

Recommended configuration: (not included)

• Motor: 2206kv2300*2pcs 
• ESC: 30A*2pcs
• Servos: 12g*2pcs
• Propeller: 5045E/ep*2pcs
• Battery:4s 1500-3300mah
• Radio: 3CH 2Servos

Excellent inner layout setting, perfect for FPV racing.

Skywalker custom made metal motor seat, ensures the flight stability.

Double motors design, powerful and reliable.

The wing is attached with PCB plate and the small wing is connected with the copper clylinder, easy to assemble, disassemble and carry.

Design with two different hatches, suitable for the placement of different cameras.

 

Following up the principle of convenience, the Skywalker SMART uses magic claps and magic belts for easy use.

The bottom is attached with thin film, protected from the scratching with two layers. 

JIE-STAR X8 Skyhunter FPV Foldable RC Drone

Foldable design? Aerial photography? One key return and one key landing? Headless mode? WIFI and transmitter control? 

Yes, yes, yes !!! The Jie-star Skyhunter X8 quadcopter has all the functions you are looking for? Easy to control, easy to carry. Flying a drone has never been so easy. 

Where to buy? https://www.fpvmodel.com/jie-star-x8-skyhunter-fpv-foldable-rc-drone_g1355.html

JIE-STAR SKYHUNTER X8 RC quadcopter is an incredible UAV whose arms and landing skids can be folded manually, making it barely bigger than your palm. It is ready to fly out of the box. Therefore, you can put the drone into nearly any bag for an outdoor activity. SKYHUNTER is a multicopter intended for beginners since One Key Takeoff, One Key Landing, One Key Return are easily accessible so that you can control the drone with ease.

JIE-STAR SKYHUNTER X8 is no doubt one of the most popular portable drone on the market. FPV Model is a business partner of Jie-star, while others sell the X8 for over $60, here we are giving you a special price of $36.99. Check the link below, to see what others say at Youtube.